DACH Apollo Controller ID Guide

1. Locate the controller

The controller on the Apollo is located under the rear seat. The seat bottom lifts off and you can access the controller.

2. Access the controller

To access the controller the rear seat bottom will need to be lifted off. It is removed by pulling up lightly from each corner. Once the seat bottom is removed you can see the controller.

3. Observe & Identify The Controller

With the seat bottom removed you can see the controller pretty easily. The controller in this model vehicle (2025) is the ENpower MC3818-7235.

4. Locate & Identify Programming Port

To locate and access the programming port you need to lift the seat to the battery bay. The Programming Port will be on the side of the battery with the electrical connections, there will be multiple plugs along the side of the battery.

5. Locate Programming Port

The programming port on the Apollo golf cart is a 4 pin black flat automotive style connector.

 
Now that we have identified the controller in your vehicle we can take a look at the required equipment to connect to the vehicle and make your desired changes.

6. Programming Cable

To establish a connection with the Enpower controller in your DACH golf cart you will need to use CartCables part # CC-CBL-ENPWCB. It can be purchased HERE

7. Programming Cable

In addition to our programming cable, you will also need our CANbus 2-to-4-pin adapter to use the standard programming cables with the 4-pin programming port on the DACH Apollo. The part number for this adapter is #CC-ADP-CAN224 It can be purchased HERE.

 

8. Programming Software

In addition to the programming cable you will need to have a copy of the "Parameter Calibrator" software loaded on your pc. WE DO NOT PROVIDE THE SOFTWARE.

Please note: We do not sell the software, just the cables.

If you have any further questions, please do not hesitate to contact us HERE.