DACH Falcon Controller ID Guide

1. Locate the controller

The controller on the Falcon is located under the rear seat, above the transaxle and motor. It can be a bit difficult to access. The easiest way to view it is from the rear of the vehicle, looking up from the ground.

2. Access the controller

The easiest way to view the controller is from underneath, at the rear of the vehicle. It is mounted upright, forward of the transaxle and motor.

3. Observe & Identify The Controller

Once you get your head up under there, you can get a decent view of the controller. As you can see on this cart (2025), the controller is the 350A JHL.

4. Locate Programming Port

The programming port is located in the battery bay next to the battery. It should be a small opaque/clear/white 4-pin square port. It has a protective cap that will need to be removed for programming.

 

Now that we have identified the controller in your vehicle we can take a look at the required equipment to connect to the vehicle and make your desired changes.

5. Programming Cable

To establish a connection with the JHL controller in your DACH golf cart you will need to use CartCables part # CC-CBL-DACHSE. It can be purchased Here.

 

6. Programming Software

In addition to the programming cable you will need to have a copy of the "JHLLive" software loaded on your pc. WE DO NOT PROVIDE THE SOFTWARE.

 

Please note: We do not sell the software, just the cables.

If you have any further questions, please do not hesitate to contact us HERE.