eNVy NV4 Controller ID Guide

1. Locate the controller

The controller on the NV4 is located under the seat in the middle of the batteries towards the backside of the vehicle. 



2. Observe & Identify The Controller

There is no cover over the controller on the NV4 model and its pretty easily to see it clearly with the seat lifted.


3. Locate & Identify Programming Port

The programming port is located in the battery bay under the seat, on top of the charger. Typically, it will have a weather protective cap that needs to be removed to connect the programming cable. Make sure you replace the cap after you are done making your changes.


4. Programming Cable - Curtis Controller

To establish a connection with the Curtis controller in your NV4 you will need to use CartCables part # CC-CBL-1309. It can be purchased HERE


5. Programming Software - Curtis Controller

In addition to the programming cable you will need to have a copy of the "Curtis 1314 PC Programming Station" software loaded on your pc. WE DO NOT PROVIDE THE SOFTWARE.

Please note: We do not sell the software, just the cables.

If you have any further questions, please do not hesitate to contact us HERE.