EVolution Classic With Curtis Controller
1. Observe & Identify The Controller
x
|
With the rear cover removed you will be able to gain access to the controller. |
2. Locate & Identify Programming Port
x
|
To locate and access the programming port you need to lift the seat to the battery bay, from the drivers side of the vehicle you will see the fuse block, there is a small opening underneath of the fuse block if you look down there with a flash light you will see 2 or 3 different cables. Its pretty tight in there to access. |
3. Locate Programming Port
x |
The programming port on the Classic model cart is a 4 pin square connector. |
Now that we have identified which controller is in your vehicle we can take a look at what is required to connect to the vehicle and make your desired changes.
4. Programming Cable - Curtis Controller
To establish a connection with the Curtis controller in your EVolution cart you will need to use CartCables part # CC-CBL-1309. It can be purchased HERE |
5. Programming Software - Curtis Controller
In addition to the programming cable you will need to have a copy of the "Curtis 1314 PC Programming Station" software loaded on your pc. WE DO NOT PROVIDE THE SOFTWARE. |
Please note: We do not sell the software, just the cables.
If you have any further questions, please do not hesitate to contact us HERE.