Gorilla H Series Controller ID Guide

1. Locate the controller

x

The controller in the H Series carts is located under the seat in the battery bay on the passenger side of the cart. It is mounted in a black protective box with the tow/run switch mounted to the cover.

 

2. Access the controller

x

To access the controller you will need to remove the cover from the controller box. With the cover removed, you can easily see the controller.

 

3. Observe & Identify The Controller

x

With the cover removed we can easily see and identify the controller.

 

4. Locate & Identify Programming Port

x

The programming port on the H Series is located close to the controller, once you locate it you can probably access it without having to remove the controller cover each time. It is a white 4 pin connector.

 

Now that we have identified the controller in your vehicle we can take a look at the required equipment to connect to the vehicle and make your desired changes.

5. Programming Cable

To establish a connection with the Enpower controller in your Alset golf cart you will need to use CartCables part # CC-CBL-ENPWCB. It can be purchased HERE

 

6. Programming Software

In addition to the programming cable you will need to have a copy of the "Parameter Calibrator" software loaded on your pc. WE DO NOT PROVIDE THE SOFTWARE.

 

Please note: We do not sell the software, just the cables.

If you have any further questions, please do not hesitate to contact us HERE.