ICON With ICON Controller

Now that we have identified the controller in your vehicle we can take a look at the required equipment to connect to the vehicle and make your desired changes.

1. Physical observation of the controller.

ICON Controller

 

2. Locate the programming port

The programming port is located in the battery bay under the seat next to the Run/Tow switch. It may have a protective cap on it which will need to be removed for the check and also during programming.

  

3. Programming Cable - ICON Controller

To establish a connection with the ICON controller in your cart you will need to use CartCables part # CC-CBL-ICONSE. It can be purchased HERE Note: The ICON Controller/Software does NOT require the additional canusb adapter that the NEOS controller uses.

 

4. Programming Software - ICON Controller

In addition to the programming cable you will need to have a copy of the "ICONLive" software loaded on your pc. WE DO NOT PROVIDE THE SOFTWARE.

  

Please note: We do not sell the software, just the cables.

If you have any further questions, please do not hesitate to contact us HERE.