ICON With NEOS Controller

Now that we have identified the controller in your vehicle we can take a look at the required equipment to connect to the vehicle and make your desired changes.

1. Physical observation of the controller.

NEOS Controller

2. Locate the programming port

The programming port is located in the battery bay under the seat next to the Run/Tow switch. It may have a protective cap on it which will need to be removed for the check and also during programming.

The NEOS programming software requires a specific CANUSB adapter be used with their software in order to establish a connection. This is NOT included with the purchase of our programming cable. It must be purchased separately, directly from the manufacturer. 

3. Programming Cable - NEOS Controller

To establish a connection with the NEOS controller in your cart you will need to use CartCables part # CC-CBL-NEOSCB. It can be purchased HERE

4. Programming Cable - NEOS Controller

In addition to our programming cable you will also need to have this specific CANUSB adapter which is NOT included with our cable- It must be purchased separately, directly from the manufacturer. Visit their site: www.canusbshop.com

 
5. Programming Software - NEOS Controller

In addition to both cables you will also need to have a copy of the "NEOS Tune" software loaded on your pc. WE DO NOT PROVIDE THE SOFTWARE.

 

Please note: We do not sell the software, just the cables.

If you have any further questions, please do not hesitate to contact us HERE.