E-Moke With 35 Pin Style MC3336 Controller

Now that we have identified the controller in your vehicle we can take a look at the required equipment to connect to the vehicle and make your desired changes. 

1. Access & Identify The Controller

When the charger is removed the controller in the Moke which is an Enpower MC3336 controller becomes clearly visible. This style features a multiwire 35-pin connector positioned on the left side of the controller when viewed from the front of the vehicle. 

 

2. Locate & Identify Programming Port

x
For units equipped with a 35-pin connector, the port is situated on the left side of the controller when viewed from the front of the vehicle. Accessing it requires removing a small rubber seal that covers the port; in some cases, you may need to adjust the controller's position slightly for easier access, though this step is usually unnecessary when using the included right angle USB extension cable. It's important to reinstall the rubber weather seal after each use to protect the port.

 

3. Programming Cable

To establish a connection with the 35 Pin Style controller in your E-Moke, you will need CartCables part number CC-CBL-ENPWUSB. It can be purchased HERE.

 

4. Programming Software

In addition to the programming cable you will need to have a copy of the "Parameter Calibrator" software loaded on your pc. WE DO NOT PROVIDE THE SOFTWARE.

 

Please note: We do not sell the software, just the cables.

If you have any further questions, please do not hesitate to contact us HERE.