E-Moke With Umbilial Style MC3336 Controller

Now that we have identified the controller in your vehicle we can take a look at the required equipment to connect to the vehicle and make your desired changes.

1. Observe & Identify The Controller

x

When the charger is removed, the controller in the Moke, which is an Enpower MC3336 controller with the "Umbilical" configuration with a cable extending from the top side toward the firewall.

 

2. Locate & Identify Programming Port

To locate the programming port on the "Umbilical" style controllers, look at the bundle of wires exiting from the top side of the controller. There will be multiple connectors between the controller and the firewall. Look for an empty, triangle-shaped 3-pin connector among these connectors. This specific connector aligns with the plug on the programming cable and is used for programming purposes.

 

3. Programming Cable - Umbilical Style Controller

To establish a connection with the Umbilical Style controller in your E-Moke you will need to use CartCables part number CC-CBL-ENPWSE. It can be purchased HERE.

 

4. Programming Software - Umbilical Style Controller

In addition to the programming cable you will need to have a copy of the "Parameter Calibrator" software loaded on your pc. WE DO NOT PROVIDE THE SOFTWARE.

 

Please note: We do not sell the software, just the cables.

If you have any further questions, please do not hesitate to contact us HERE.