Moto Electric Eclipse With Curtis Controller

Now that we have identified which controller is in your vehicle we can take a look at what is required to connect to the vehicle and make your desired changes.

1. Observe & Identify The Controller

Curtis Controller

 

2. Locate & Identify Programming Port

 
The programming port is located in the battery bay under the seat next to the Run/Tow switch. It may have a protective cap on it which will need to be removed for the check and also during programming.

 

3. Programming Cable - Curtis Controller

To establish a connection with the Curtis controller in your Eclipse cart you will need to use CartCables part # CC-CBL-1309. It can be purchased HERE

 

4. Programming Software - Curtis Controller

In addition to the programming cable you will need to have a copy of the "Curtis 1314 PC Programming Station" software loaded on your pc. WE DO NOT PROVIDE THE SOFTWARE.

Please note: We do not sell the software, just the cables.

If you have any further questions, please do not hesitate to contact us HERE.