Moto Electric Eclipse With NEOS Controller

Now that we have identified which controller is in your vehicle we can take a look at what is required to connect to the vehicle and make your desired changes.

1. Observe & Identify The Controller

NEOS Controller

 

2. Locate & Identify Programming Port

The programming port is located in the battery bay under the seat next to the Run/Tow switch. It may have a protective cap on it which will need to be removed for the check and also during programming.

 

Now that we have identified the controller in your vehicle we can take a look at the required equipment to connect to the vehicle and make your desired changes.

3. Programming Cable - NEOS Controller

To establish a connection with the NEOS controller in your cart you will need to use CartCables part # CC-CBL-NEOSCB. It can be purchased HERE

 

4. Programming Cable - NEOS Controller

In addition to our programming cable you will also need to have this specific CANUSB adapter which is NOT included with our cable- It must be purchased separately, directly from the manufacturer. Visit their site: www.canusbshop.com

 
5. Programming Software - NEOS Controller

In addition to both cables you will also need to have a copy of the "NEOS Tune" software loaded on your pc. WE DO NOT PROVIDE THE SOFTWARE.

 

Please note: We do not sell the software, just the cables.

If you have any further questions, please do not hesitate to contact us HERE.