Sierra LSV AX Series Controller ID Guide

1. Locate the controller

The controller on the AX Series carts is located in the battery bay under the seat on the passenger side of the cart. It is located underneath a black plastic protective cover. (Shown in topside of this photo above)


2. Access the controller

To access the controller the cover will need to be removed. It is held on with 4 #3 phillips head screws. Once the screws are removed the cover can be removed.


3. Observe & Identify The Controller

With the cover removed you can see the controller pretty easily. The controller in this model vehicle is made by Enpower.


4. Locate & Identify Programming Port

The programming port on the AX Series cart will be located xxxxxxx The programming port is a 2 pin black flat automotive style connector.


Now that we have identified the controller in your vehicle we can take a look at the required equipment to connect to the vehicle and make your desired changes.

5. Programming Cable

To establish a connection with the Enpower controller in your Alset golf cart you will need to use CartCables part # CC-CBL-ENPWCB. It can be purchased HERE


6. Programming Software

In addition to the programming cable you will need to have a copy of the "Parameter Calibrator" software loaded on your pc. WE DO NOT PROVIDE THE SOFTWARE.


Please note: We do not sell the software, just the cables.

If you have any further questions, please do not hesitate to contact us HERE.