EVolution D-MAX Controller ID Guide

So far, EVolution is only using the C-model controller in D-MAX vehicles.
If your vehicle is a 4WD version, it’s important to note that it will have two controllers, and both will need to be adjusted when making changes.

Below, you'll find an overview of the components, how to locate them, and what’s required to access and adjust the settings.

1. Access & Identify The Controller (Rear)

The main rear controller on the D-MAX is mounted under the rear seat bottom cushion, just forward of the rear axle. The easiest way to access and inspect the controller is by removing the rear seat bottom cushion. You won’t need any tools—simply pull up on each of the two front corners of the seat cushion, and they will pop loose. Once both latches are released, the cushion should lift up and slide out or off.

With the cushion removed or lifted, the controller will be located on the passenger side of the vehicle. On some models, the label is mounted on the underside, facing the ground, making it a bit tricky to view. In these cases, we recommend using a cellphone camera—extend your arm down and snap a photo to read the label.

 

2. Check the controller model number
The model number can be found on the product label located on the side of the controller. Typically, it is on the same side as the 35-pin multi-connector, but in some cases, it may be on the opposite end. EV48-400-C Model Shown Above.

 

3. Locate Controller Model Number - EV48-400-C
EV48-400-C Model Controller Pictured Above

 

4. Locate & Identify Programming Port (Rear)

x
To locate and access the programming port you need to lift the seat to the battery bay

 

5. Locate Programming Port (Rear)

x
The programming port on the D-MAX model cart is a 4 pin square connector.

  

Now that we have identified which controller is in your vehicle we can take a look at what is required to connect to the vehicle and make your desired changes.

 

6. Programming Cable - EVolution Controller

To establish a connection with the EVolution controller(s) in your D-MAX cart you will need to use CartCables part # CC-CBL-EVO2SE. It can be purchased HERE

 

7. Programming Software - EVolution EV48-400-C Controller

In addition to the programming cable you will need to have a copy of the "GEF12HOSST" OR "EV48-400-C" software loaded on your PC. WE DO NOT PROVIDE THE SOFTWARE.

Please note: We do not sell the software, just the cables.

If you have any further questions, please do not hesitate to contact us HERE.