EVolution D5 2+2 With EV48-400 OR EV48-400-A Controller

 

1. Observe & Identify The Controller

EV48-400 Controller.

 

2. Locate & Identify Programming Port

The programming port for the D5 2+2 will be located right near the controller in the same compartment behind the rear seat. Its a white square 4 pin connector.

 

3. Locate Programming Port

The programming port on the D5 model cart is a 4 pin square connector.

  

Now that we have identified which controller is in your vehicle we can take a look at what is required to connect to the vehicle and make your desired changes.

 

4. Programming Cable - EVolution Controller

To establish a connection with the EVolution controller in your Classic cart you will need to use CartCables part # CC-CBL-EVO2SE. It can be purchased HERE

 

5. Programming Software - EVolution EV48-400 / EV48-400-A Controller

In addition to the programming cable you will need to have a copy of the "EV Programming Tool" software loaded on your PC. WE DO NOT PROVIDE THE SOFTWARE.

Please note: We do not sell the software, just the cables.

If you have any further questions, please do not hesitate to contact us HERE.