Moke America E-Moke Controller ID Guide

1. Locate the controller

 x
The controller on the Moke America E-Moke is located under the hood in the front battery bay. It is on the driver side of the vehicle underneith the charger.

 

2. Access the controller

x
To access the controller the battery charger will need to be removed. It is held on with screws along the edge. Once the screws are removed the charger can be removed.

 

3. Observe & Identify The Controller

x
With the charger removed you can see the controller pretty easily. The controller in this model vehicle is made by Enpower.

 

4. Locate & Identify Programming Port

x
The programming port for the E-Moke will be located right on the side of the motor controller itself. When standing at the front of the vehicle it will be along the left side of the controller. There is a small rubber seal that must be removed to access the programming port. In some vehicles it maybe necessary to loosen and move the controller to get access. Typically this step is NOT needed when used with the right angle usb extension cable included with our programming cable. Make sure to reinstall the rubber weather seal on the programming port after each use!

 

Now that we have identified the controller in your vehicle we can take a look at the required equipment to connect to the vehicle and make your desired changes.

5. Programming Cable

x
To establish a connection with the Enpower controller in your E-Moke you will need to use CartCables part # CC-CBL-ENPWUSB. It can be purchased HERE

 

6. Programming Software

In addition to the programming cable you will need to have a copy of the "Parameter Calibrator" software loaded on your pc. WE DO NOT PROVIDE THE SOFTWARE.

 

Please note: We do not sell the software, just the cables.

If you have any further questions, please do not hesitate to contact us HERE.